Gear Measurement

General

Profile, bearing area and roughness measurement
Universally usable, since suitable for (almost) all gear types
Automated measurement system
Structure, pit measurement at the root
Comparison between true data and drawing contour + texture
Optimisation of the gear flank micro structure
Problem evaluation and assistance for optimisation
Head and root cone measurement, pits,scuffing
Spur pinions, crown gears, conical gear wheels, spur toothed or helical gearing

Technical Data

Design features

Modular setup on a granite base plate. Using a 4-D measurement unit both tooth flanks are measured in the tooth gaps in one measurement run. When measuring a spiral gearing the measurement block will be slanted.
The pick up is protected by a suitable housing.

Spur gear

Pinion diameter max.	[mm]	160
Range module	[mm]	0.4-8
Range tooth width	[mm]	30
Centre width	[mm]	20-150
Floating fixture
Wheel mass max.	[kg]	30

Internal gear

Wheel diameter max.	[mm]	300
Range module	[M]	0.4-8
Range tooth width	[mm]	30
Fixture in toothed wheel	[mm]	300
Wheel mass max.	[kg]	30

Conical gear wheel

Wheel diameter max.	[mm]	300
Range module	[M]	1.5-8
Range tooth height	[mm]	30
Wheel mass max.	[kg]	30

Measurement direction: radial. After each profile line the gear is rotated by a suitable angle and also moved vertically.The part is fixed in the hole. The position with respect to roundness, wobble, run out is taken into account when calculating the surface topography.

Applications

zahnrad1a

Spur pinion

zahnrad2a

Internal gear

zahnrad1c

Conical gear wheel

Data sheet

Gear Measurement

Data sheet: GearMeasurement.pdf

end faq

< Prev		Next >